You may not be correctly shutting the detergent dispenser cover, or a cycle was not finished and should be cancelled. If an air gap is installed at sink, it may be clogged Make certain the filter system isn’t clogged The kitchen sink drain may be clogged you may need a plumber rather than a serviceman for the dishwasher. Make certain a portion of the drain hose is at least 20 inches above the dishwasher’s enclosure floor. Make certain the drain hose isn’t kinked, clogged, or improperly installed. Go to the Adding Detergent and Rinse Agent section of this manual for instructions on increasing the amount of rinse agent dispensed Check the water supply valve and open it if it’s shut Run the water until it runs hot, then turn off the water and start the dishwasher Before starting the dishwasher, open the hot water faucet at the sink nearest the dishwasher. If the dishwasher completes the cycle, but the run time seems exceptionally long, it may be due to cold incoming water. Make certain the dishwasher door is shut and latched The dishwasher door may not be properly shut. Check the fuse or circuit breaker at your fuse box/breaker box and replace the fuse or reset the breaker if necessary Dishware drying can be accelerated and enhanced by opening the dishwasher door slightly and propping it open with the top rackĪ fuse may have blown or a circuit breaker tripped. Check the rinse-aid dispenser and refill it if necessary. Other model Bosch classixx dishwasher troubleshooting Problem Smears left behind on glasses and cutlery glasses have acquired a metallic appearance Glasses become clouded and discoloured coating cannot be wiped off Too much salt was spilt while filling container. Salt content in washing water is too high. Detergent does not have a sufficient bleaching effect. Tea stains or traces of lipstick have not been completely removed Items were removed from dishwasher too soon. Selected programme did not include drying function. If you used a phosphate-free detergent, try a detergent containing phosphates and compare results.ĭishes, cutlery, etc. Lid on salt container is not screwed tight. Although water is quite hard, no salt has been put in appliance. Not enough detergent was added to input compartment. White stains are left on crockery, glasses have a milky appearance Use a detergent containing a chemical bleaching agent. Detergent has insufficient bleaching properties. Nozzles in spray arm are blocked by remnants of food. Rotation of spray arm was obstructed by dish, etc. Selected wash programme was not intensive enough. Not enough detergent was added to dispenser. Items in the rack were touching each other. Jets of water could not reach all parts of the dishes, etc. Remnants of food are stuck to the dishes, cutlery, etc. This is caused by the way the water pipes have been laid and it has no effect upon the way the appliance functions. Crockery has not been stacked properly inside the appliance. Rattling sound can be heard while washing is taking place A spray arm is knocking against the dishes inside the appliance. Knocking sound can be heard while washing is taking place Cut in electricity supply to appliance. Remove any spilled rinse aid with a cloth as it could otherwise lead to excessive foaming during the next washing cycle.Īppliance stops suddenly while washing is taking place Normal washing up liquid has been poured into the rinse-aid container. Wait for the programme to end (programme-end display will illuminate). Water remains inside appliance after programme has ended Compartment must be dry before detergent is added. Compartment was damp when it was filled up with detergent. Remnants of detergent stuck inside dispenser Indicator lamps do not extinguish after washing has finished Indicator lamps do not extinguish after washing has finished. Mechanism is clogged with remnants of detergent. Detergent compartment has been overfilled. Lid in detergent compartment cannot be closed Spray arm is blocked by small items or food remains. The strainer is situated in the Aquastop or supply-hose connection. Fault with fuse in mains electricity supply.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |